Crane-composites CLEANROOM WALL SYSTEM User Manual

Where Tradition & Innovation Converge Installation Guidefor Cleanroom Wall System featuringwith trim-free seams

Seams Around Doors and window Frames and Other Special Application Areas1. Repeat process listed in Vertical Flat Panel Seams.2. Material should be

AN IMPORTANT NOTE ABOUT MOISTURE RESISTANT SUBSTRATESMOISTURE-RESISTANT GYPSUM VARIES TREMENDOUSLY, WHILE SOME OF THESE NEW SURFACES ALLOW MOISTURE TO

Form #7616 | Rev. 03 | 07.14 (7052)www.CleanroomWallPanels.com | [email protected]

Figure 1TopicsGeneral Information 2Installation Preparation 3Pre-Installation Planning 5Basic FRP Installation Steps 5Cutting Inst

Supplies and EquipmentSupplies will vary depending on wall substrate and adhesive choice• Crane Composites Standard FRP • Adhesive - Crane Advanced P

NEW GYPSUM BOARD OR DRYWALLNew gypsum should not be painted or primed. Tapered joints need only a fi ll and taped coating using a setting joint compou

ADHESIVE RECOMMENDATIONS FOR VARIOUS SUBSTRATESRefer to form #6846 for additional Crane Adhesive installation information.Pre-Installation Planning• P

Cutting InstructionsPOSITION PANEL FACE DOWN ON A COVERED WORK AREAWhen cutting with a circular saw, position the panel so that the saw blade enters t

Panel and Seam Sealant SequenceAll panels are installed prior to the seam treatment. Before caulk and sealant can be applied, installed panels need t

Seam Sealant Workability Time1/8” - 3/16” Bead IMPORTANT INSTALLATION NOTE Seam Sealant workability begins at initial dispenseApply Ur

7. Remove horizontal tape and begin next 3’ section. A good technique is to apply the sealant below the previous section and “bump up” the sealant i